Barrow 16 Channel SATA Power, 6Pin - 5v RGB Controller with Remote [DK301-16]

Barrow and Barrowch was established in 2010. It is an export-oriented and domestically-manufactured manufacturing enterprise specializing in computer and industrial water cooling equipment and precision hardware components. The advanced design concept and internal structure are deeply loved by domestic and foreign enthusiasts of water cooling players.

Features:
- Fully programmable RF Remote control
- 16 Channel Multi Output option interface
- LRC 2.0 RGB 5v Lighting, compatible with Aura Sync, MSI Mystic, Gigabyte RGB, Asrock LED and Barrow LRC Controllers
- High production quality and strict QC

Technical Data:
Channels: 16
Input: SATA Dual voltage Power (5v and 12v)
Output Interface: 6 Pin special interface
Output Option1: 3 Pin Fan
Output Option2: 4 Pin Fan
Output Option3: 3 PIN with 3 Wires (Flow meters)
Output Option4: 3 PIN with 2 Wires (Temperature meters)
Control: RF Remote controle / Motherboard lighting Sync

Motherboard Sync (Hub Mode):
- To connect this controller to your motherboard to act as an RGB Hub you need to switch the RF switch on the main board to the OFF position.

- Once in the OFF position you use the 6Pin cable that comes with the product, connect that on to any 6Pin connector on the Controller and use the 5v (3pin) Lighting interface to plug this into your 5v Output on your motherboard.

- When that is connected, your Barrow 16 Port controller becomes a 15 Port Hub, and accepts the RGB signal from the motherboard via the Lighting interface.

Note: You also need to plug in the 4Pin 12V Interface into any Motherboard Fan header.

Non Motherboard Sync (RF Controller Mode):
- To use the Barrow 16 way Controller as a controller for all your RGB lighting, simply ensure the RF Switch on the main board is set to the ON position, and use the RF Remote (make sure to add a battery) to cycle and change colours.

Included:
1x Barrow 16 Way SATA Power, 6Pin - 5v RGB Controller with Remote (1 x CR2025 Battery not included)

Note: You may need to remove the wings on 3Pin and 4Pin connectors as shown above to use the fan / led with this controller.