Alphacool flow indicator G1/4 with rpm signal - Plexi [17176]

Connect to a main board:
The flow sensors will be detected from the main board like a normal 3-pin fan. Normally it is possible to set the main board software this way, that depending on the rotation speed (or if there is no rotation at all) the computer will be shut down. This makes it possible to have a very good and save way to protect the hardware without additional costs.

Connect to a fan controller:
The flow sensor will be detected and will get the input of the rotation speed like a normal 3-pin fan. If the fan controller includes a Display and / or an alarm function, they can be used also with the flow sensor.

Connect to an electronic device:
The signal from the flow sensor will be detected as a “puls” and can be calculated to the needed unit of measurement (for example l/h or g/h). If you use an Alphacool Heatmaster, it is possible to start an alarm when the flow rate is too low or even to shut down the computer.

Technical data:
Material: Plastic
Threads: G1/4
Measurements: Length: 46mm, outside diameter: 52mm
Cable length: 33cm
Cable plug: 3-pin