DEMCiflex Dust Filter 80mm Square black / white [80MM TYPE2/MAGNETS]

The safest way this can be seen at the fan itself, being present on the outer side of the fan frame two arrows. Shows one of the two arrows in the direction of the interior, there is a one-sucking fan. These are usually located at the front, side and bottom, while the rear and top fans usually carry the air from the housing and therefore does not need to be filtered.

Are all the fans the same size, so should have more fans blowing out than move into the housing. Here, the power supply as an additional, pulling out fan is to be included, unless it's supply (fan page) is not directly from the outside (it happens when floor mounted). Is it different fans with different sizes and speeds to give the corresponding volume of air (m³ / h) in the data sheets for a good reference value, which in turn the overall volume of an absorbent must be higher than that of the fan blowing out.

Note: The area around the used slot fan should be flat and have no protruding parts where possible. This may otherwise interfere with the adhesion to the substrate.

Technical details:

    Size (frame): 105 x 105 mm
    Size (filter): 80 x 80 mm
    Compatibility: 80mm fan slot
    Material (filter): polyester mesh
    Color: black (part), white (filter)
    Installation: mounting frame + magnetic support
    Benefits:
    Fast assembly
    No compatibility restrictions
    Quick and easy cleaning
    Effective filter effect at high air permeability
    Durable fabric