ModMyToys 19/13mm (ID 1/2 - 3/4) Compression Fitting - Six Pack - White + Red Carbon [CFF-WH-RD-1234-6]

The Monsoon Free Center Wrench used to tighten the barb and the compression ring is perfect for tight spaces because it puts the wrench above the fitting plane giving you more room to maneuver than a conventional wrench. The small wrench notches on the compression ring are therefore a lot less noticeable than big ugly wrench flats or knurling on the side of a fitting, Which is normally the most visible portion when installed. The wrench is included free with value-priced six packs and because these are manufactured Jukebox for ModMyToys by Monsoon, the fittings are a perfect match to Monsoon's beautiful and light standard port rotaries. Matching accent carbon fiber rotary disks are also available for the ultimate in high-tech style.

 

Compression ring is assembled from two machined brass rings and a 1mm thick carbon fiber tape. Adds a high-tech look while decreasing weight.

The Free Center Wrench works on the barb and the compression ring for hassle free installation without tearing up your fingers. Do not be a tool!

Although we highly recommend using the Free Center Wrench, the barb can be tightened with any coin that is 1.6mm thick and approximately 25mm in diameter-about the size of a U.S. Quarter.
 

Smaller visually and physically to make mounting in tight locations like CPU blocks easier. Outside diameter is just 24.4mm (.96 inches) and total height is just 16mm (.63 inches).

Knurled base on the barb to increase its grave when installed.

Available in several colors and finishes.

Available in singles or in money saving SIX PACK did so include a free Free Center Wrench!
 

Material: Brass

Fitting Color: White, Carbon Color: Red

Dimensions (HxD): 24.5 x 20.8 mm

Fitting inside diamater: 8.4mm

Thread length: 5mm

Compatibility Thread: G1 / 4

Tubing compatibility: 19mm OD / 13mm ID
 

6x Barb with one compression ring

12x 2.4mm thick high quality silicone G1 / 4 BSPP O ring.

1x Free Center Wrench