EK Water Blocks EK-MOSFET Sabertooth P67 - Acetal [3831109815069]

Modern CPUs are increasingly integrating functions that were previously taken traditionally by the motherboard chipset (memory controller, GPU-slot connection). This also has the side benefit of lower heat generation on the board. On the other hand, the supply of the CPU demanding, so that the voltage converter now constitute the main heat source on modern motherboards.

While in the past for water cooling primarily North and South Bridge were covered, then the voltage transformers are recommended for such a measure. The watercooling specialist EK Water Blocks is now offering the Asus Sabertooth P67 motherboard to a corresponding voltage transformer cooler.

To make this even in an overclocked state always remains in the green range of temperatures. For this, the floor was made entirely of copper, which guarantees a high thermal conductivity. But visually it is a real gem.

Connection is via two 1/4 inch thread. Connections are not included. Thermal compound is necessary for the assembly that are not included.

Note: Due to the design, the plastic cover of the Sabertooth motherboard to install this cooler to be removed! The cooler can therefore not be used in combination with this cover.

Technical details:
Material: Copper (base), acetal (cover)
Thread: 2x 1/4 inch
Compatibility:
Asus Sabertooth P67 (P67, Socket 1155)

Notes This heatsink is suitable only for the Asus Sabertooth P67 motherboard! Where there are protective foil on the bottom must be removed before installation. To install the EK radiator of the original cooler from Asus has to be removed, whereby a guarantee against loss is associated to the manufacturer. Any changes made at your own risk! We assume no liability for damages caused by faulty or improper installation and improper use!