EK Water Blocks EK-FC7990 SE - Acetal + Nickel [3831109868218]

This water block directly cools both GPUs, RAM as well as both VRMs (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC7990 SE water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps.

Base is made of electrolytic copper while the top is made of quality cast acrylic material. The sealing is performed by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure. Block is mounted with enclosed M3x4 DIN7985 and M3x6 DIN7991 screws allowing for reinstallation of factory provided backplate.

Up to four EK-FC7990 SE water blocks can be interconnected using EK-FC Terminal system or other methods of interconnectivity. This water block does not align with any other FC water block apart from EK-FCS10000 & EK-FCW9000. This water block is not compatible with EK-FC Bridge CSQ series interconnect!

Enclosed:
- EK-FC7990 SE series water block
- mounting mechanism with screw-in brass standoffs
- thermal pads

Please note: Thermal paste is not included and needs to be purchased separately. EKWB recommends Gelid GC-Extreme for best performance.

Made in Slovenia - Europe!

CAUTION:
- Due to immense variety of fittings/barbs available on market and no prescribed standards, we guarantee compatibility only for connectors bought from our web site.