Thanks to the nickel-plated electrolytic copper block, efficient cooling of the GPU, memory and voltage converter is guaranteed. The heat sink provides a chic look thanks to its black aluminum design and integrated RGB LED lighting. As a highlight, the magnetically attached side logo can be easily changed and the design can also be individualized.
The TechN RTX 2080 GPU water cooler water cooling block at a glance:
- Custom-fit for RTX 2080 graphics cards in reference design
- Effective cooling performance thanks to nickel-plated electrolytic copper base
- Chic look thanks to the acrylic lid and aluminum design in black
- Exchangeable side logo with magnetic holder
- Four G1 / 4-inch connections for integration into the circuit
- Integrated RGB LED lighting with 12V RGB LED strip
Why should I cool my graphics card with water?
Top performance is still bought in the graphics card segment with an equally top heat development. Because the decisive advantage over the competing products can only be achieved if the clock screw is turned as far as it will go and the calculation units are used right down to the last segment. Smaller structure widths and more efficient layouts can limit this problem, but they cannot be completely eliminated. Because, as expected, the next generation will be challenged to the maximum.
The problem is exacerbated by overclocking because the temperatures can reach critical values. In short: If you want a low volume in gaming or even benching and possibly want to turn the clock screw at the same time, you can hardly avoid water cooling. In addition to the usual components (radiator, pump, expansion tank), a suitable cooler for the graphics card is of course necessary - like this model from the German manufacturer TechN.
Optics and connections of the TechN RTX 2080 GPU water cooler
It is a full block design, which covers all relevant heat sources of the graphics card and thus effectively cools - i.e. the GPU, the memory and the voltage converter. Nickel-plated electrolytic copper is used to optimally transfer the heat.
The lid made of transparent acrylic glass is adorned with a black anodized aluminum cover including integrated 12V RGB LED lighting. The connection terminal has four holes (G1 / 4-inch thread). Due to the flat design of the cooler, the connection of several graphics cards in a graphics card network is possible without any problems.
Note 1: Connections that are not included in the scope of delivery are required for integration into the cooling circuit. Thermal paste and thermal pads are already included to make contact between the cooler and graphics card. Make sure that the cooler is only suitable for NVIDIA graphics cards of the type RTX 2080! The original cooler must be removed before assembly, which can invalidate the manufacturer's guarantee!
- Material: nickel-plated copper (bottom), acrylic (lid), anodized aluminum (housing)
- Color: Black
- Dimensions: 265 x 125 x 26 mm (W x D x H)
- Weight: 1062 g
- Thread: 4x G1 / 4 inches
- Illumination: 4-pin RGB (12VGRB, 12V)
- Compatibility: NVIDIA GeForce RTX 2080 reference design
- operation manual
- Pre-installed thermal pads
- Thermal Compounds
- 13x M3x4mm screws
- 15x washers
- 2x M3x6mm screws and nuts
Attention: Please note that some coolers are delivered with a protective film on the bottom. This must always be removed before assembly and commissioning. We accept no liability for damage caused by incorrect or incorrect assembly and improper use!