Spectrum ARGB Hub 3 pin with 3 pin power v1.61 Button Operation [ARGBHUBV1.6]

Spectrum ARGB Hub 3pin with 3pin power v1.61 also supports manual mode, which has built-in over 100 colour modes by RGB switch on the controller. Built-in PWM function, makes all the fans sharing PWM signal input from motherboard for auto-speed control by noise control.

Key Features

Built-in program > 100 modes.
7 dynamic colours.
Automatic and manual control.
Mode and colour adjustment.
Brightness adjustment. (Can be Selected)
SATA power supply.
The normal 3pin fan have the PWM fan function. Enjoy auto-speed control.
Compatible with programmable RGB interface of Rainbow, Sync AURA motherboard.
Can connect light strips of ASUS.

Specifications

Input Requirements:
- Input Voltage: The power supply interface is SATA. The SATA allows positive and negative connections.
Functions:
- Turn On or Off: Press mode and colour button for three seconds,
- Default: When first installed it defaults into the seven colour modes.
- Change Mode and Colours: Press mode and colour button to change the mode and press the mode twice and colour colour button twice to change the colours in the same mode.
- Increase or Decrease the Brightness: Press brightness button to the adjust the brightness of the LEDs.
- MB Rainbow AURA Sync: After connecting the motherboard programmable RGB interface, allowing you to change your LED
- Fan Control: The fan speed is controlled by the PWM signal of the mainboard and the connection on fan number 1 have sense speed detection - function to display CMOS of the motherboard
- 3pin Strips: Two connections allow you to connect LED strips with ASUS standard.
Other Specifications:
- LED Connectors Qty: 5
- LED Connectors: 3pin ARGB
- Fan Connectors Qty: 5
- Fan Connectors: 3pin Fan
- Other Connectors: 1 x 4pin PWM in, 1 x 2pin Switch, 2 x 3pin Strip & 1 x ARGB M/Board
- Powered Via : SATA
- Fan Conections: 5 (Fan 1 has sense speed detection function)
- AURA Connections: 5 (The triangle mark on the connector is aligned with the arrow on the controller)
- MB Rainbow: MB Rainbow is connected to the motherboard programmable RGB interface onboard. The triangle mark on the plug is aligned with the arrow on the controller.
- SATA Connection: SATA is the power supply interface and Output 5V and 12V DC voltage.
- PWM-In: PWM-In connects to the motherboard PWM fan interface (SYS-FAN or CHA-FAN socket onboard).
- SW Switch: SW is the switch interface. Some cases have multi-functions, mode and colour control and some products have brightness adjustment - function. Reserve touch switch button interface. Please note that the V1.61 only has mode / colour control.
- Test: The Test interface is the PWM demo function interface. When the PWM fan is not connected to the motherboard, Test (1 and 2 shortage by - Jumping) are connected to drive the fan to run full speed.
- Fan Output: 3W
- LED Output: 2W