PrimoChill System Reboot - Cooling Loop Treatment [PC-SBOOT]

1.Install your cooling loop and double-check connections to ensure loop is “closed”. No Leaks!
2.Empty bottle of ReBoot into 1 US Gallon of fresh DI or Distilled water, and shake for 30 seconds
3.Add mix to cooling loop.
4.Fill loop with treated solution and be sure to remove as many air bubbles as possible.
5.Start loop pump and begin circulating the treated solution.
6.Run treated solution for at least 24 to 48 hours to ensure loop is properly flushed and treated.  While using for longer periods of time doesn't have negative effects, ReBoot is not an effective final coolant and should be replaced with coolant before any extended use of computer.
7.Drain System. Inspect drained solution for debris or foreign particles. Dispose of drained solution. Repeat flush if needed.
8.Fill system with fresh DI or distilled water and flush thoroughly to remove ReBoot solution checking for foam.
9.Drain system.**.
10.Fill loop with your choice of coolant and begin water-cooling.

** Reboot needs to be flushed from the system until no foam is seen and water runs clear

1.Install your cooling loop and double-check connections to ensure loop is “closed”. No Leaks!
2.Fill entire loop with DI or distilled water. (leave room for System Reboot)
2.Add Full bottle of the system ReBoot Pre-Treatment.
3.Top off with DI or distilled water if needed.
4.Start loop pump and begin circulating the treated solution.
5.Run treated solution for at least 24 to 48 hours to ensure loop is properly flushed and treated.  While using for longer periods of time doesn't have negative effects, ReBoot is not an effective final coolant and should be replaced with coolant before any extended use of computer.
6.Drain System. Inspect drained solution for debris or foreign particles. Dispose of drained water. Repeat flush if needed.
7.Fill system with fresh DI or distilled water and flush thoroughly to remove ReBoot solution checking for foam.
8.Drain system.**.
9.Fill loop with your choice of coolant and begin water-cooling.

** Reboot needs to be flushed from the system until no foam is seen and water runs clear