EK-FC Radeon Vega RGB is a high-performance full-cover water block for multiple AMD® Radeon® Vega based graphics cards that comes with pre-installed 4-pin 12V RGB LED strip.
This water block directly cools the GPU, HBM2 memory, and VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC Radeon Vega water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. This kind of efficient cooling will allow your high-end graphics card to reach higher boost clocks, thus providing more performance during gaming or other GPU intense tasks. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps.
This product is compatible with popular RGB sync technologies from all major motherboard manufacturers. The arrow marking on the 4-pin LED connector is to be aligned with the +12V marking on the RGB header. You can easily remove the LED strip cover which is mounted with two screws to replace the LED strip with some other type LED strip.
The base of the block is CNC machined out of nickel-plated electrolytic copper while the top is CNC machined out of high-quality acrylic material. The sealing is ensured by quality rubber O-rings. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.
EKWB recommends the purchase of aesthetic retention backplate which improves the looks of your graphics cards and also provides some passive cooling to the circuit board VRM section. The EK-FC Radeon Vega water block is compatible with both Nickel and Black versions of the EK-FC Radeon Vega Backplates.The EK-FC Radeon Vega water block is also compatible with the factory backplates of all Radeon Vega based graphics cards (except AIO liquid cooled versions).
EK also encloses a single-slot I/O bracket which replaces the original two-slot in order to make installation of multiple graphics cards easier and also transforms the GPU into a gorgeous single slot solution.
The block also features a special plastic cover over the block Terminal. This add-on is designed to reveal the Radeon logo, visible from the side. The terminal cover is removable, it is fitted with 2 screws from the side.
G1/4" threaded fittings can be used on both sides of the FC terminal and for multiple GPU connectivity, please refer to our offer of GPU Terminals.
The EK-FC Radeon Vega water block is compatible with all reference Radeon Vega Frontier Edition, Radeon RX Vega 64, Radeon RX Vega 56 design based graphics cards. The current compatibility list rounds up a total of 6 graphics cards that are on the market, but as always, we recommend that you refer to the EK Cooling Configurator for a precise compatibility match.
- RGB cable length: 30cm
- RGB connector classic 4-pin (12+ R G B)
- EK-FC Radeon Vega RGB series water block
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- 2x EK plug G1/4”
- 6mm Allen key
- Thermal pads
- Thermal grease EK-TIM Ectotherm (1g)