To connect the individual components of the water cooling system to choose the right connections and the adequate number is essential. Otherwise the installation will quickly into a frustrating experience if the assembly fails at the wrong or a few joints and been delayed due to his.
Bitspower offers a comprehensive range of this, which holds for each claim the right solution - whether adapters, direct hose connections, angle or distributor. Execution is always solid, and has a sealing ring. Ensure that the connections remain tight and long term durability.
This angled at 45 degrees 1/4 inch connector (fitting) for tubes with inner diameter of 13mm does not use nut, so any tube thicknesses and therefore outside diameter can be used. The blood-red port can be rotated on the side of the screw thread. This greatly facilitates the installation and allows a precise alignment.
Note: For better and more secure fit we recommend using a cable tie or a hose clamp. Further, the rotation function of the connections are always used when removed, as this is by design relatively sluggish. In the installed state should not force exerted on connections, not to damage the connectors themselves and the cooler thereon.
Thread: 1/4 inch
Hose: 13 mm (internal diameter)