Alphacool Eisbecher D5 250mm Acetal reservoir incl. 1x Alphacool EisPumpe VPP755 [13308]

The lighting module illuminates from above. Small riser pipes and Bubble Down also do their work faultlessly here. The Eisbecher can be mounted either with the mounting bracket or with the included stands. If there is room in the 3.5" hard drive cage inside the case, the pump socket also has threads for this (requires pump decoupling with M4 inner and outer threads - Art. no. 52007).

Scope of Delivery

    8x M4x12mm screws
    8x M4x8mm screws
    4x M4 nuts
    1x mounting ring
    1x O-ring ID ca. 54mm
    2x stands
    1x 2.5mm hex key

Dimensions for 250mm version

    Dimensions incl. bracket without stands (LxWxH): 277.5 x 136 x 80mm
    Dimensions without bracket incl. stands (LxWxH): 324 x 87.5 x 80mm
    Plexiglass tube diameter: 60mm
    Capacity: 360ml

Assembly instructions

The VPP755 Eispump

The Alphacool VPP755 Eispump improves on the classic D5 VPP655 pump in every way. There is no area where it is weaker or louder than its predecessor, and it instead offers new ways to control the pump to your liking.

Technical Specifications

    Dimensions (DxH): 60 x 53.5mm
    Cable length: 50cm
    Standard voltage: 12V DC
    Power consumption: 14W
    Permitted voltage: 8-13V DC
    Pressure at 12V: 4m water head
    Maximum flow rate: 350l/h
    Pump medium: water, water/glycol mixture
    Maximum system temperature: 65ºC
    Power connection: 4-pin molex
    Tach signal: 3-pin
    PWM signal: 4-pin
    Special feature: adjustable in five levels
        Level 1: 1800 RPM
        Level 2: 2500 RPM
        Level 3: 3200 RPM
        Level 4: 3900 RPM
        Level 5: 4500 RPM

Scope of Delivery

    Alphacool Eisbecher D5 250mm Acetal incl. 1x Alphacool Eispump VPP755

Download 3D-file (.stp)

Notice
In order to use the inlet from above, a G1/4" extension piece is required (art. no. 1011183-1011186), as the thread is embedded a few mm into the cap and many screw threads will not be able to reach it.

CAUTION

Removing the impeller from the ceramic shaft will cause the upper ceramic clamping ring to over-expand, which will destroy it! Removal will void the pump’s warranty!

If the pump is put together again and put back into operation, the clamping ring will loosen, which is not accepted as grounds for a return or exchange...