Aquacomputer aquadrive Micro - Copper [25125]

Downright wasteful worked with this HDD cooler with the valuable raw material copper.Thus, the aquadrive from a full copper plate is milled. Thus, the cooler is also very difficult, since copper has a high density. The most important advantage of this choice of material is extremely good heat conduction. Even hotheads like Raptors or SCSI drives spinning at high speed to stay cool, which brings a high service life. The flow resistance is relatively low because the channels were designed with very wide 16mm.

This is the cooler with 6mm (without connection terminals) very flat, allowing for high compatibility. At the same time provides the micro aquadrive the opportunity to use both sides as the cooling surfaces and thus cooling two drives. More information is contained in the set, a small wrench to even the sides to allow for tightening.

However, this use would be for aesthetic reasons almost too good, especially for the front page looks with the stainless steel plate neatly worked out extremely elegant and decorated it evaluates each interior clearly.

Because of the connection terminals can not have two IDE hard drives can be combined, since the connections of one of the HDDs would be covered. Accordingly, either two SATA and one IDE or a SATA drive can be combined. This rule does not apply if the case allows for bringing the cable from both side. The required standard screws are not included.

Specifications:
Height: 6 mm (without connection terminals)
Material: copper, stainless steel
Thread: 2x G1 / 4 inches
For: 1x SATA / IDE, 2x SATA, 1x SATA and 1x IDE (each 3.5 inches)