Aquacomputer Pump adapter for DDC pumps for aqualis base with fill level sensor, G1/4 [41097]

 A mounting bracket made from stainless steel is included in delivery, an optional decoupling set can also be used (not included in delivery). For mounting a DDC series pump, suitable screws are provided.

When used with an aqualis base series reservoir, pump adapter and reservoir form a virtually seamless unit. The sockets at the base of the reservoir slide into form-fitting receptables of the pump adapter and the gaskets on the sockets establish a watertight seal. When used with a reservoir, the threads on the side of the pump adapter must be used to connect the water loop. Additionally, a fill level sensor of the mps series is integrated into the pump adapter. The fill level sensor features an integrated microcontroller with USB and aquabus interface, a programmable alarm output and an external temperature sensor input. For monitoring and configuration, the aquasuite software can be downloaded free of charge. In addition to the USB interface, the 4-pin aquabus interface can be used to directly connect the flow sensor to an aquaero 5 controller (not included in delivery). The alarm output can be configured to be used as a rpm signal to be connected to a fan connector with fault detection (for example motherboard fan headers) or to be used as a switched output for example to connect a LED. Fill level and external temperature sensor input can be configured to raise an alarm. The external temperature sensor input is compatible with all Aqua Computer temperature sensors. A pressure equalisation membrane is included in delivery of the pump adapter and is to be installed into the top port of the reservoir. 

When used without an aqualis base series reservoir, the fill level sensor is not operational! G1/4 inlet threads for fittings can be used on the top and side of the pump adapter, the pressure side is always connected to a G1/4 port on the side. The unused inlet thread can be sealed with a G1/4 sealing screw supplied with the pump adapter.

Compatibility list for aquabus interface:
aquaero 6 XT (art. 53146 and 53206)
aquaero 6 PRO (art. 53145)
aquaero 5 XT (art. 53125 and 53089)
aquaero 5 PRO (art. 53090)
aquaero 5 LT (art. 53095)

Compatibility list for external temperatue sensor input:
Temperature sensor inline G1/4 (art. 53066)
Temperature sensor inner/outer thread G1/4 (art. 53067)
Temperature sensor G1/4 (art. 53147)
Temperature sensor plug&cool (art. 53025)
Temperature sensor 70 cm (art. 53026)

Scope of delivery:
Pump adapter
Stainless steel bracket
Pressure equalisation membrane with G1/4 thread
Internal USB cable
Mounting material
Two G1/4 sealing screws