High-flow barb fitting for hoses with an inner diameter of 11mm up to 13mm.

Technical data:
Thread: G1 / 4
Overall length: 21mm
Inner diameter of hose 11 to 13mm
Inner diameter of fitting: 0.8 cm
Thread length: 8mm

Features:
Suitable for SLI-operation between two graphics cards

Note for watercooling beginners:
The connectors for imperial hoses (7 / 16 ", 3 / 8 ", ½ ") are provided with measurements in mm in our shop. These can differ by +-1mm, Which is no problem as hose clamps have to be used for installation . If the hose is to be mounted without a clamp chosen, a larger fitting should be. With some fittings that tend to be larger, though it is possible that a hose with an inner diameter of 13mm actually does seal without a hose clamp.