A well-known problem and here is the solution!

What is the best management to Prevent kinking hose, how to avoid angled connectors to allow maximum flow? Now a well-known technology has been adopted to the cooling water sector by our designers to allow a solution Which before was only possible with multiple different fittings.

The core of the ball fitting Allows free adjustment of the barb, up to at angle of 30 °. Even if using the full possibilities of this fitting the flow rate is barely compromised. The knurling on this fitting Allows easy and quick tool-free installation.

This fitting gives many new possibilities unknown before!

Technical specifications:
Material: Silver nickel-coated
Height (without thread): 38mm
Diameter bottom end: 20mm
Hose fitting length: 24mm
Fitting inner diameter: 8mm
Thread length: 5mm

Extent of delivery:
1x 10mm (3 / 8 ") barbed fitting G1 / 4 with O-ring gasket (high flow) - ball rotation - nickel silver

Note for watercooling beginners:
The connectors for hoses (7 / 16 ", 3 / 8", 1 / 2 ") are provided with measurements in mm in our shop. These can differ by +-1mm, Which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp chosen, a larger fitting should be. With some fittings that tend to be larger, though it is possible that a hose with an inner diameter of 13mm actually does seal without a hose clamp.

Overview:
10mm (3 / 8 ") hose clamp: up to 8mm none, from 10mm up required
10mm (7 / 16 ") hose clamp: up to 8mm none, from 10mm up required
12mm (1 / 2 ") hose clamp: 11mm up to none, from 12mm up required
13mm (1 / 2 ") hose clamp: 11mm up to none, from 13mm up required